Setting up the Projector Using
Password Setting
([5]Password)
Carrying out security protection using password.
setup>5 |
|
| 1 | |
Password | : |
|
|
|
Please Enter | : sharppj |
|
| 2 |
|
| |||
(change) | * | |||
1Enter “5” and press the “Enter” key.
2Enter password and press the “Enter” key. Display set password (*).
Projector Name Setting
([7]Projector Name)
It is possible to assign a projector name.
setup>7 |
|
Projector Name | : |
Please Enter | : MY |
(change) | MY |
1Enter “7” and press the “Enter” key.
2 Enter projector name. Display set projector name (*).
1
2
*
Note
•Password can be up to 8 characters.
•You can input the characters below :
•In the default state, the password is not set.
RS-232C Baud Rate Set-
ting ([6]RS-232C Baud Rate)
Setting of baud rate for
setup>6 | 1 | ||||
0 | ... | 9600 bps |
|
| |
1 | ... | 38400 bps |
|
| |
2 | ... 115200 bps |
|
| ||
Baud Rate |
|
| 2 | ||
|
| ||||
* | |||||
|
|
|
| ||
1Enter “6” and press the “Enter” key.
2Select and enter the number 0, 1 or 2 and press the “Enter” key.
Display set baud rate (*).
Note
•Set the projector’s baud rate to the same rate as that used by the computer.
Note
•Projector name can be up to 12 characters.
•You can input the characters below :
(When
•It is the same as the name which can be con- firmed or set, using
DHCP Client Setting
([8]DHCP Client)
Setting DHCP Client to “Enable” or “Disable”.
Example: When setting DHCP Client to “Enable”
setup>8 | 1 |
note: It sets DHCP Client. |
|
0 ... | Disable |
|
|
|
|
1 ... | Enable |
|
|
|
|
DHCP |
|
| 2 | ||
|
| ||||
DHCP Client : Enabled |
|
| |||
Success get data from DHCP server. |
|
| |||
[MAC Address | ] : [XX:XX:XX:XX:XX:XX] |
|
| ||
[IP Address | ] : [192.168.150.2] | * | |||
[Subnet Mask | ] : [255.255.255.0] | ||||
[Default Gateway | ] : [0.0.0.0] |
|
| ||
[DHCP IP Address] : [192.168.150.1] |
|
| |||
1Enter “8” and press the “Enter” key.
2 Enter “1” and press the “Enter” key. Display the obtained values (*).
-35
