Sherwood R-771 manual Connecting System Control, SUBWOOFER PREOUT connection, Connecting Speakers

6. CONNECTING SYSTEM CONTROL

•Connect this jack to the DIGI LINK jack of the external Sherwood component that uses the DIGI LINK II or III remote control system.

7. SUBWOOFER PREOUT connection

•To emphasize the deep bass sounds, connect a powered subwoofer.

8. CONNECTING SPEAKERS

•Be sure to connect speakers firmly and correctly according to the channel(left and right) and the polarity(+ and -). If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connection is incorrect, the sound will be unnatural and lack bass.

•For installing the speakers, refer to "Speaker placement" on page 10.

•After installing the speakers, first adjust the speaker settings according to your environment and speaker layout.(For details, refer to "SETTING THE SPEAKER / ROOM EQ SETUP" on page 43.)

Surround back speakers

•When using only one surround back speaker, you should connect it to SURROUND BACK/ROOM 2 LEFT channel.

•If you assign the power amplifier for the surround back/ room 2 channels to the ROOM 2, this unit can drive the speakers in another room (ROOM 2).

(For details, refer to "CONNECTING ROOM 2 OUTs" on page 11 and "When selecting the AMP ASSIGN" on page 37.)

Caution :

•Be sure to use the speakers with the impedance of 6 ohms or above.

•Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or the speakers.

ENGLISH

9