Introduction

Introduction

READ THIS BEFORE OPERATING YOUR UNIT

This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

CAUTION

: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO

This symbol is intended to alert the user to the presence

NOT REMOVE COVER (OR BACK). NO USER-

 

 

 

SERVICEABLE PARTS INSIDE. REFER SERVICING

of important operating and maintenance (servicing)

 

instructions in the literature accompanying the appliance.

 

TO QUALIFIED SERVICE PERSONNEL.

 

 

WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,

DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

Caution regarding installation

Note : For heat dispersal, do not install this unit in a confined space such as a bookcase or smilar enclosure.

ENGLISH

Do not block ventilation openings or stack other equipment on the top.

Note to CATV System Installer :

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

Caution : Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FOR YOUR SAFETY

U.S.A

CANADA

120 V

Units shipped to the U.S.A and CANADA are designed for operation on 120 V AC only. Safety precaution with use of a polarized AC plug.

However, some products may be supplied with a nonpolarized plug.

CAUTION : To prevent electric shock, match wide blade of plug to wide slot, fully insert.

ATTENTION : Pour éviter chocs électriques, introduire la lame la plus large de la fiche dans la borne correspondante de la prise et pousser jusqu’ au fond.

CAUTION

Leave a space around the unit for sufficient ventilation.

Avoid installation in extremely high or cold locations, or in an area that is exposed to direct sunlight or heating equipment.

Keep the unit free from moisture, water, and dust.

Do not let foreign objects in the unit.

The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.

No naked flame sources, such as lighted candles, should be placed on the unit.

Please be care the environmental aspects of battery disposal.

The unit shall not be exposed to dripping or splashing for use.

No objects filled with liquids, such as vases, shall be placed on the unit.

Do not let insecticides, benzene, and thinner come in contact with the set.

Never disassemble or modify the unit in any way.

Notes on the AC power cord and the wall outlet.

The unit is not disconnected from the AC power source(mains) as long as it is connected to the wall outlet, even if the unit has been turned off.

When disconnecting the power cord from the wall outlet, always pull the plug, not the power cord.

Disconnect the plug from the wall outlet when not using the unit for long periods of time.

The wall outlet shall be installed near the unit and shall be easily accessible.

3

Page 4
Image 4
Sherwood R-771 manual Introduction, Read This Before Operating Your Unit, For Your Safety, English