SETTING THE SYSTEM SETUP
• AMP ASSIGN : To assign the surround back channel's power amplifier to ROOM 2 for ROOM 2 playbak.
• OUT ASSIGN : To assign the ROOM 2/TAPE OUTs to TAPE REC for analog audio recording.
•SUBWOOFER MODE : To select the desired subwoofer mode.
•TONE CONTROL : To adjust the tone (bass and treble) as
desired.
• CINEMA EQ : To select the desired cinema EQ mode.
• MOMENTARY OSD : To turn on or off the OSD that shows the status corresponding to each operation momentarily.
•OSD POSITION ADJUST : To adjust the positon of the momentary OSD and the OSD menu.
When selecting the items other than OSD POSITION ADJUST
Press the CURSOR UP( )/DOWN( ) buttons to select the desired item.
1
ENGLISH
Press the CURSOR LEFT( )/RIGHT( ) buttons to set the selected item as desired.
2
When selecting the AMP ASSIGN
•You should assign the power amplifier for the surround back/room 2 channels to ROOM 2 when the SURROUND BACK/ROOM 2 speaker terminals are connected to the speakers installed in another room for ROOM 2 playback. In this case, you need not use the power amplifier to drive the speakers additionally. (For details on ROOM 2 connection, refer to "CONNECTING ROOM 2 OUTs" on page 11.) SURR BACK : To use power amplifier for the surround back channels.
ROOM 2 : To use it for ROOM 2 playback.
Note : When the EXTERNAL IN is selected as a main source, the AMP ASSIGN is automatically set to "SURR BACK".
When selecting the OUT ASSIGN
•Depending on how to use the ROOM 2/TAPE OUTs, you should assign these to ROOM 2 or TAPE REC. ROOM 2 : To use the ROOM 2/TAPE OUTs for ROOM 2 playback
(For details on ROOM 2 connection, refer to "CONNECTING ROOM 2 OUTs" on page 11.) TAPE REC : To use them for analog audio recording.
(For details on connection, refer to "CONNECTING AUDIO COMPONENTS" on page 8.) Note : When the AMP ASSIGN is set to "ROOM 2" or the ROOM 2 mode is turned on, the OUT ASSIGN is
automatically set to "ROOM 2".
37
