Sherwood R-771 Listening in a Dolby Headphone mode, Adjusting each channel level with test tone

ENGLISH

Continued

To cancel the surround mode for stereo operation

• Depending on the signal format which is being input, either the stereo mode or the 2CH downmix mode is selected.

• To cancel either the stereo mode or the 2CH downmix mode, select the surround mode with using the MULTI CONTROL knob on the front panel or the SURROUND MODE UP/DOWN ( >/< ) buttons on the remote control.

2CH downmix mode

•This mode allows the multi-channel signals encoded in DTS or Dolby Digital format to be mixed down into 2 front channels and to be reproduced through only two front speakers or through headphones.

•When the SPEAKER button is set to off to listen with headphones, if the STEREO button is pressed while playing the multi-channel digital signals from DTS or Dolby Digital sources, it will enter the 2CH downmix mode automatically.

•To cancel the 2CH downmix mode, select the desired Dolby Headphone mode with using the MULTI CONTROL knob on the front panel or the SURROUND MODE UP/DOWN ( >/< ) buttons on the remote control.

Listening in a Dolby Headphone mode

•The Dolby Headphone function simulates 5.1 channel surround sound, which allows you to enjoy 5.1 channel surround sound through 2 channel headphones, just like listening from 5.1 channel speakers.

Notes :

•Only when the SPEAKER button is set to off, the Dolby Headphone mode can be selected.

•When playing the 96 kHz PCM(2 channel) digital signals, only the stereo mode can be selected.

•While listening with headphones, select the desired Dolby Headphone mode.

• Each time the MULTI CONTROL knob is rotated or the SURROUND MODE UP/DOWN ( >/< ) buttons are pressed, the mode changes as follows :

DH 1 : This simulates the soundfield as if you were in a relatively small room

with less reverberations.

DH 2 : This simulates the soundfield as if you were in a typical listening room

with moderate reverberations.

DH 3 : This simulates the soundfield as if you were in a large space like theater.

Adjusting each channel level with test tone

• The volume level of each channel can be adjusted easily with the test tone function.

Note : When the SPEAKER button is set to off or it is in the stereo mode, the test tone function does not work.

Enter the test tone mode.

1

•The test tone will be heard from the speaker of each channel for 2 seconds as follows:

FL	C	FR	SR
Front Left	Center	Front Right Surround Right
SW	SL (	SB) or (	BL	BR)
Subwoofer	Surround Left	Surround Back	Surr.Back Left	Surr.Back Right

•When the speaker setting is "NONE", the test tone of the corresponding channel is not available.

•( ) : Possible depending on whether the surround back channel is set to "2 CH" or "1 CH".

2	At each channel, adjust the level as	Cancel the test tone function.
	desired until the sound level of each	3
	speaker is heard to be equally loud.

26