Operations
Notes:
•Before operating this receiver with the supplied remote control, refer to "Universal Remote Controls" on page 15 for details about operation.
•Before operating this receiver, first set this unit as desired for optimum performance, doing the OSD menu setting procedures. (For details, refer to "OSD Menu Settings" on page 35.)
ENGLISH
LISTENING TO A PROGRAM SOURCE
Before operation
• Enter the standby mode.
• The POWER ON/STANDBY button lights up in amber. This means that the receiver is not disconnected from the AC mains and a small amount of current is retained to support the operation readiness.
•To switch the power off, push the POWER switch again.
•Then the power is cut off and the POWER ON / STANDBY button goes off.
In the standby mode, turn the power
1 on.
•Each time the POWER ON/STANDBY button on the front panel is pressed, the receiver is turned on to enter the operating mode (the POWER ON/ STANDBY button lights up in blue) or off to enter the standby mode(the POWER ON/STANDBY button lights up in amber).
•On the remote control, press the POWER ON button to enter the operating mode or press the STANDBY button to enter the standby mode.
•In the standby mode, if the INPUT SELECTOR button is pressed, the receiver is turned on automatically and the desired input is selected.
Switch the speakers on.
2
•Then the SPEAKER indicator lights up and the sound can be heard from the speakers connected to the speaker terminals.
•When using the headphone for private listening, press the SPEAKER button again to switch the speakers off.
Select the desired input source.
3
•Each time the "AUDIO" button on the front panel is pressed, the input source changes as follows;
TUNER CD AUX TAPE
(frequency display)
•Each time the "VIDEO" button on the front panel is pressed, the input source changes as follows;
| VIDEO 1 | VIDEO 2 | VIDEO 3 VIDEO 4 |
|
|
| |||
|
|
|
|
|
When selecting the EXTERNAL IN as desired,
•Depending on the power amplifier setting for the surround back channels and the surround back speaker setting, "EXT IN" is displayed and 8(/7/6) separate analog signals from the component connected to this input pass through the tone and volume circuits only and can be heard from your speakers.
•Press the EXTERNAL IN button or select the desired input source to cancel the external in function.
•These analog signals can be heard only, not recorded.
21
