ENGLISH
USING FUNCTIONS OF REMOTE CONTROL
•This remote control can control up to 8 different components.
•Before operating audio and video components other than this receiver with using this remote control, the setup code for each component should be entered.
•For system remote control operation, "000" was stored previously in the memory of the device button "CD" for Sherwood CD player, "DVD" for Sherwood DVD player, "AUX" for Sherwood tape deck and "TV" for Sherwood TV respectively as its factory setup code. So, you don’t need to enter its code for each Sherwood component except in such a case that its code does not work.
�Note :
•If the transmission signal which this remote control emits is changed into "RF"(Radio Frequency), this remote contol cannot control other audio and video components. (For details, refer to "Changing the transmission signal" on page 28.)
Entering a setup code
•Setup code entry is the easiest way to program this remote control for operating audio and video components.
1. Turn on the component you want to operate.
2. Find the setup codes according to the type and the brand name of your component, referring to "Setup Code Table" on page 73.
3. Press and hold down both the ENTER button and the desired one of the DEVICE buttons for more than 2 seconds.
•Then "LEARN" is displayed on the LCD screen for several seconds.
�Notes :
•The AUDIO button is unavailable for the audio components other than this receiver.
•During setting operation, to exit from the setting mode, press any of the DEVICE buttons.
4. While "LEARN" is displayed, press the CURSOR UP(▲)/DOWN(▼) buttons to select the setup code mode ("CODE"), then press the ENTER button.
•Each time the CURSOR UP(▲)/DOWN(▼) buttons are pressed, the mode changes as follows :
�LEARN �
�CODE � PUNCH �
•Then "PRESET" and 3 digit number are displayed.
•If "PRESET", etc. go off, start again from the above step 3.
5. While "PRESET", etc. are displayed, enter a 3 digit code and press the ENTER button, aiming the remote sensor on the component.
Example: When entering "001".
•Then "OK" is displayed on the LCD screen.
•To be sure that the setup code is correct, press the POWER ON (or STANDBY) button.
•If the setup code is correct, your component will be turned off.
•When your component is not turned off, repeat the above steps 2 to 5, trying entering each code for your component until you find one that works.
•If "NG" is displayed, retry entering the correct setup code while "PRESET" and 3 digit number are displayed.
20
