ENGLISH
10. CONNECTING ROOM 2 OUTS
•ROOM 2 playback feature allows you to play a different program source in another room as well as one source in the main room at the same time.
•For ROOM 2 playback, connect the ROOM 2 OUT jacks to the amplifier, TV, etc. installed in another room, or connect the ROOM 2 speaker terminals to the speakers.
•Because this receiver cannot drive the surround back speakers and the ROOM 2 speakers simultaneously, you should assign their power amplifier correctly depending on how to use them. (For details, refer to "When selecting the AMP ASSIGN" on page 49.)
•When the ROOM 2 (AUDIO) OUT jacks are not connected to the ROOM 2 amplifier, you can connect these jacks to audio recording equipment such as a tape deck, an MD recorder, etc. for analog audio recording. (For details, refer to "CONNECTING AUDIO COMPONENTS" on page 8.)
�Notes :
•To minimize hum or noise, use high quality connection cords.
•You cannot use the digital audio signal for ROOM 2 playback.
11. CONNECTING RF REMOTE ANTENNA
• Connect the supplied antenna to receive the RF (Radio Frequency) beams from the universal remote control.
•If the antenna is connected to this receiver, even though there are obstacles such as walls, furniture, etc. in the way, you can control this receiver with the universal remote control. Therefore, you can control this receiver from another room with the universal remote control without connecting the
�Note:
• If the walls are too thick or the distance exceeds the operation range, you cannot control this receiver with the universal remote control. In such a case, connect the
(For details, refer to "Changing the transmission signal" on page 28.)
12
