Sherwood R-772 manual Erasing the programmed command from one button, English

R-772(A)2007.8.165:21PM페이지23

Erasing the programmed command from one button

1. Perform the steps 3 and 4 in "Entering a setup

code" procedure on page 20 to select the delecting mode ("DELETE").

•Then "BTTN" is displayed on the LCD screen for several seconds.

2. While "BTTN" is displayed, press the CURSOR

UP(▲)/DOWN(▼) buttons to select the one command deleting mode (BTTN), then press the ENTER button.

•Each time the CURSOR UP(▲)/DOWN(▼) buttons are pressed, "BTTN" or "LEARN"(all command deleting mode) is selected.

•Then "SEL" is flickering.

•If "SEL" goes off, start again from the above step 1.

3. While "SEL" is flickering, press the button for the

command you want to erase.

Example: When the button for the command to be erased is PLAY button.

•"OK" is displayed and then "SEL" is flickering.

4.While "SEL" is flickering, repeat the above step 3 to erase other commands.

Erasing all the commands programmed under a device mode

1. Perform the steps 3 and 4 in "Entering a setup

code" procedure on page 20 to select the deleting mode ("DELETE").

•Then "BTTN" is displayed on the LCD screen for several seconds.

2. While "BTTN" is displayed, press the CURSOR

UP(▲)/DOWN(▼) buttons to select the all command deleting mode ("LEARN"), then press the ENTER button.

•Then "SURE?" is displayed .

•If "SURE?" goes off, start again from the above step 1.

3. While "SURE?" is displayed, press the ENTER

button.

• Then all the commands programmed are erased.

4. To erase all the commands programmed under

other device mode, repeat the above steps 1 to 3.

ENGLISH

23