Sherwood R-772 manual Setting The Ch Level Setup, Adjusting the current channel level, English

R-772(A)2007.8.165:21PM페이지64

SETTING THE CH LEVEL SETUP

ENGLISH

Memory mode

■Note :

•Depending on the speaker settings("NO", etc.), some channels cannot be selected.

Adjusting the current channel level

•You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory("CALIBRATE"), not into preset memory("REFERENCE 1", "REFERENCE 2").

•After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit your tastes.(For details, refer to "Adjusting each channel level with test tone" on page 35.)

1. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired channel.

■When adjusting the LFE LEVEL

①. Press the CURSOR UP(▲)/DOWN(▼)buttons to select the LFE LEVEL SETUP, then press the ENTER button.

②. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired program source.

2. Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to adjust the level of the selected channel or program source's LFE as desired.

• The LFE level can be adjusted within the range of -10 ~ 0 dB and other channel levels within the range of -15 ~ +15 dB

• In general, we recommend the LFE level to be adjusted to 0 dB.(However, the recommended LFE level for some early DTS software is -10 dB.) If the recommended levels seem too high, lower setting as necessary.

3. Repeat the above steps 1 and 2 to adjust each channel level.

64