• | I | _- | 1:53 | _'_/_,_ |
Introduction
READ THIS BEFORE OPERATING YOUR UNIT
:TO REDUCE THE RISK OF ELECTRIC CAUTION SHOCK, DO NOT REMOVE COVER (OR
BACK). NO
INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
uninsulated "dangerous voltage" within the product's
//_This symbol is intended to alert the user to the presence of enclosure that may be of sufficient magnitude to constitute
a risk of electric shock to persons.
important operating and maintenance (servicing)
This symbol is intended to alert the user to the presence of instructions in the literature accompanying the appliance.
WARNING:TO REDUCE THE RiSK OF FiRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THiS APPLIANCE TO RAiN OR MOISTURE.
Caution regarding installation
Note : For heat dispersal, do not install this unit in a confined space such as a bookcase or similar enclosure.
|
|
|
|
|
|
|
| r/ |
|
|
|
|
|
|
|
| wo, |
|
|
|
|
|
| i_ | l l' | _ l l / / _/'/ l l l l l l_!// |
Do | not | block | ventilation | openings | or stack other equipment | on | the | top. |
Note | to | CATV | System | Installer : |
|
|
|
|
This reminder is provided to call the CATV system installer's attention to Article
FCC iNFORMATiON
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Caution : Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This Class B digital apparatus complies with Canadian
Cet appareil numerique de la Classe B est conforme a. la norme
U.S.A
120 V
CANADA
Units shipped to the U.S.A and CANADA are designed for operation on 120 V AC only.
Safety precaution with use of a polarized AC plug.
However, some products may be supplied with a nonpolarized plug. CAUTION:TO prevent electric shock, match wide blade of
plug to wide slot, fully insert.
ATTENTION:Pour eviter chocs electriques, introduire la lame la plus large de la fiche dans la borne correspondante de la prise et pousser jusqu' au fond.
ENERGY STAR ® is a U.S. registered mark. As an
ENERGY STAR® Partner, Sherwood has
detem_ined that this product meets the ENERGY
STAR ® guidelines f'or energy ef'fieiency.
Leave a space around the unit for sufficient ventilation.
Avoid installation in extremely hot or cold locations, or in an area that is exposed to direct sunlight or heating equipment.
Keep the unit free from moisture, water, and dust. Do not let foreign objects in the unit.
The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers,
Please be care the environmental aspects of battery disposal. The unit shall not be exposed to dripping or splashing for use.
No objects filled with liquids, such as vases, shall be placed on the unit.
Do not let insecticides, benzene, and thinner come in contact with the set.
Never disassemble or modify the unit in any way. Notes on the AC power cord and the wall outlet.
The unit is not disconnected from the AC power source(mains) as long as it is connected to the wall outlet, even if the unit has been turned off.
To completely disconnect this product from the mains, disconnect the plug from the wall socket outlet.
When setting up this product, make sure that the AC outlet you are using is easily acceptable.
Disconnect the plug from the wall outlet when not using the unit for long periods of time.
II