Sherwood R-904N manual 4, CONNECTING DIGITAL INS, 5, CONNECTING SUBWOOFER PRE OUT

•	I R-904_(A)	_	E_O	_	09Z007:R-904_(A)	2009-Z0-Z4	_	J_lo_/€_,_
							o$	Z:53 ..... :I,>,

Continued

mHDMI (High Definition Multimedia interface) connection : ('1)

. You can connect the source component (BD player, etc.) to the display component (TV, projector, etc.) through this receiver with using a commercially available HDMI cord.

. The HDMI connection can carry uncompressed digital video signals and digital audio signals.

. The HDMI video stream signals (video signals) are theoretically compatible with DVI-D. When connecting to a TV monitor,!/ etc., equipped with DVI-D connector, it is possible to connect using a commercially available HDMI-DVl converter cord.

Since the HDMI-to-DVl connection cannot carry any audio signals, set the "HDMr' to "AMP" to hear the HDMI digital audio signals on this receiver. (For details, refer to the "When selecting the "HDMI (HDMI Audio Out)" on page 25.)

mCopyright protection system

. This unit supports HDCP (High-bandwidth Digital Contents Protection), technology to protect copyright of digital video signals against illegal duplication. HDCP must also be supported on the components connected to this unit.

. This unit is HDMI Vet. 1.3 compatible.

. HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI licensing LLC.

mNotes :

. For stable signal transfer, we recommend using HDMI cords that are a maximum of 5 meters in length.

*Among the components that support HDMI, some components can control other components via the HDMI connector. However, this unit cannot be controlled by another component via the HDMI connector.

*The audio signals from the HDMI connector (including the sampling frequency and bit length) may be limited by the component that is connected.

*The video signals will not be output properly if a component incompatible with HDCP is connected.

*If the resolutions of the video signals which are output from the MONITOR OUTs and your monitor TV are not matched, the picture is not clear, natural or displayed. In this case, change the setting of the resolution on the source component (DVD player, etc.) to one which the monitor TV can handle. (For details, refer to the operating instructions of the source component.)

*When you want to enjoy only the picture on your TV, not the sound, you should set the "HDMr' to AMP not to output the digital audio signal from the HDMI MONITOR OUT of this receiver. (For details, refer to "When selecting the "HDMI (HDMI Audio Out)" on page 25.)

4, CONNECTING DIGITAL INS

*The OPTICAL and the COAXIAL DIGITAL

OUTs of the components that are connected to this unit can be connected to these DIGITAL iNs.

*When making the COAXIAL DIGITAL connection, be sure to use a 75 _ COAXIAL

cord, not a conventional AUDIO cord. mNotes :

*Be sure to make either a OPTICAL or a COAXIAL DIGITAL connection on each

component. (You don't need to do both.)

. If you connect the DIGITAL INs to your components, you should assign the DIGITAL INs correctly. (For details, refer to "When CD, AUX, VIDEO 1, VIDEO 2("V2/IPOD") is selected as an input source" on page 20.)

5, CONNECTING SUBWOOFER PRE OUT

* To emphasize the deep bass sounds, connect a powered subwoofer.

/ ........