Sherwood R-904N manual OPERATINGCOMPONENTSWITHREMOTECONTROL1, Remote Control Operation Range

•	I R-904_(A)	_	E_O	_	09Z007:R-904_(A)	2009-Z0-Z4	_	j_]o_/€_
							o$	Z:53 ..... :I,>....

OPERATINGCOMPONENTSWITHREMOTECONTROL1

1.Enter the setup code for each component other

than this receiver. For details, refer to "Entering a setup code" on page 16.

REMOTE CONTROL OPERATION RANGE

. Use the remote control within a range of about 7 meters (23 feet) and angles of up to 30 degrees aiming at the remote sensor.

U

2, Turn on the component you want to operate.

3, Press the DEVICE button on the remote control

corresponding to the component you wish to operate.

4, Aim the remote control at the REMOTE

SENSOR of the component you wish to control and press the button corresponding to the operation you want.

.In such a case that some components do not have the REMOTE SENSOR which receives the remote signals, this remote control cannot operate them.

LOADING BATTERIES

•When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within several minutes after removing old batteries.

•If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared. Should this happen, you should memorize them again.

1, Remove the cover. 2, Load two batteries ("AAA" size, 1.5V) matching

the polarity.

i

/

LJ

J

,Remove the batteries when they are not used for a long time.

. Do not use the rechargeable batteries (Ni-Cd type).

. Be sure to use alkaline batteries.