ENGLISH
USING FUNCTIONS OF REMOTE CONTROL 
•This remote control can control up to 6 different components.
•Before operating audio and video components other than this receiver with using this remote control, the setup code for each component should be entered.
•For system remote control operation, "000" was stored previously in the memory of the device button "DOCK" for Sherwood iPod dock, "DVD" for Sherwood DVD player and "TV" for Sherwood TV respectively as its factory setup code. So, you don’t need to enter its code for each Sherwood component except in such a case that its code does not work.
Entering a setup code
1. Turn on the component you want to operate.
2. Find the setup codes according to the type and the brand name of your component, referring to "Setup Code Table" on page 62.
3. Press and hold down both the ENTER button and the desired one of the DEVICE buttons for more than 1 seconds.
• The SET LED will flicker once.
�Note :
•The "AVR" button is unavailable for the audio components other than this receiver.
4. Enter a 3 digit code, aiming the remote control at the remote sensor on the component.
Example: When entering "001".
•If entering is performed successfully, the SET LED will flicker twice.
•To be sure that the setup code is correct, press the POWER ON (or STANDBY) button. If your component is turned off, the setup code is correct.
•When your component is not turned off, repeat the above steps 2 to 4, trying each code for your component until you find one that works.
�Notes:
•If the SET LED did not flicker twice, then repeat the above steps 3 to 4 and try entering the same code again.
•Manufacturers may use different setup codes for the same product category. For that reason, it is important that you check to see if the code you have entered operates as many controls as possible. If only a few functions operate, check to see if another code will work with more buttons.
5. Repeat the above steps 1 to 4 for each of your
components.
18
