Sherwood RD-7503 manual Adjusting each channel level with test tone, English, Continued

RD-7503(A)2008.11.41:45PM페이지26

ENGLISH

Continued

�To cancel the surround mode for stereo operation

• Depending on the signal format which is being input, either the stereo mode or the 2CH downmix mode is selected.

• To cancel either the stereo mode or the 2CH downmix mode, select the surround mode with using the MULTI CONTROL knob on the front panel or the SURROUND MODE UP/DOWN (�/�) buttons on the remote control.

�2CH downmix mode

•This mode allows the multi-channel signals encoded in DTS or Dolby Digital format, etc. to be mixed down into 2 front channels and to be reproduced through only two front speakers or through headphones.

•When the SPEAKER button is set to off to listen with headphones while playing the multi-channel digital signals from DTS or Dolby Digital sources, etc., it will enter the 2CH downmix mode automatically.

Adjusting each channel level with test tone

•The volume level of each channel can be adjusted easily with the test tone function. �Note : When the SPEAKER button is set to off, the test tone function does not work.

1. Enter the test tone mode.

• The test tone mode is displayed and will be heard from the speaker of each channel for 2 seconds as follows:

→ FL → C →				FR →	SR
Front Left		Center	Front Right		Surround Right
	SUB	← SL (	←	SB )	or ( SBL ← SBR) ←
Subwoofer		Surround Left		Surround Back Surr.Back Left Surr.Back Right

• When the speaker setting is "NO", the test tone of the corresponding channel is not available.

• ( ) : Possible depending on whether the surround back channel is set to "2 CH" or "1 CH".

2. At each channel, adjust the level as desired until the sound level of each speaker is heard to be equally loud.

• You can select the desired channel with pressing the

CONTROL UP/DOWN (▲/▼) buttons or the CURSOR

UP/DOWN (▲/▼) buttons.

3. Cancel the test tone function.

26