Shindaiwa DGW310MC, DGW310DMC owner manual Change Oil Filter, Clean/Change Air Element

2) Change Oil Filter

1st	At 50 hrs
2nd or after	Every 200 hrs

1	Drain the oil as described in
	『	(1)Change Engine Oil .
2			』
	Remove the oil filter using an oil filter wrench.
3	Smear a little engine oil on the rubber			gasket of a new filter.
4	Screw the new filter into place and tighten it by
	Hand until the gasket contact seat. Then give it
	additional 1.1/4 turns using an oil filter wrench.
5	Supply engine oil.

Caution

＜ If an oil＞filter wrench is not available to get, contact our authorized distributor or our service section to change.

Oil Filter Part No.:15853-32433 (Kubota)

After supplying engine oil, keep the engine drive for

a while to check no engine oil leakage and then stop the engine

(3) Clean/Change Air Element

Clean		1st at 50 hrs 2nd or after 100 hrs
Change		Every 400 hrs
				Air Cleaner	Clip
1 Loosen the wing bolts in the cleaner and					ﾟ
remove the air element.
2 Clean or replace the air element.
＜	Dried contaminants adhere
			＞
Blow up compressed air from inside
the element.
Carbon or oil adhere					Air Cleaner cap
＜		＞		Air element

Replace to a new one. 3 Reinstall it in reverse order.

Clip

34 ﾟ

Oil filter

Gasket