![](/images/new-backgrounds/1213948/21394833x1.webp)
(3) The ELCB has activated
Caution: Electric Shock/Injuries
Be sure to disconnect all the loads to the equipment when turning the breaker ON again after ELCB has activated.
ELCB lamp (Red) turns ON and the breaker lever positions at the middle of and OFF .
In that case, reset the ELCB per the following procedure after having finished the leaked points.
1.Push the reset button.
2.Push the breaker lever down to OFF .
|
|
| 『 | 』 | 『 | 』 | 『ON』 | 『 | 』 |
The above procedure brings restoration of the breaker lever to |
| ON . |
|
|
| ||||
Caution | > |
|
|
|
|
|
|
| |
< |
|
|
|
|
|
|
|
| |
| In the case ELCB monitor lamps keep OFF on using, it means that |
|
|
|
AC Output over supply or AC output Supply under output selector switch positions at ECO. Refer to
Operation | to recover. | 『 |
5-7. Slow-down』 Feature
The
In the case of using the
△Caution: Damage to properties
When using the load with magnet switch, turn the
Caution |
|
| 『 | 』 |
| |
< | > |
|
|
|
|
|
| When the load less than 0.5A are connected to use, the | |||||
| sometimes. So, turn the switch OFF . |
|
|
| ||
|
| 『 | 』 |
| OFF . | |
| When welding and AC supply are used alternately or intermittently, turn the switch | |||||
|
|
| 『 | 』 | 『 | 』 |
| When the output selector switch is at | ECO ,the engine does not turn to high speed. |
|
15