Shindaiwa 82051 Starting cold engine, Stop Switch, Throttle Position, Choke, Purge Bulb, English

Starting cold engine

•Provide all operators of this equipment with the Operator's Manual and instructions for safe operation.

•Before starting the unit, equip yourself and any other person work- ing within the 15 m (50 ft.) Safety Zone with the required Protective Equipment and clothing.

1.Stop Switch

Move stop switch button (A) away from the STOP position.

2.Throttle Position

Move throttle position lever (B) midway between idle and full throttle positions.

3.Choke

Move choke (C) to "Cold Start" () Position.

4.Purge Bulb

Pump purge bulb (D) until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an additional 4 or 5 times.

IMPORTANT

Recoil starter: Use short pulls - only 1/2-2/3 of rope for starting. Do not allow the rope to snap back in. Always hold the unit firmly.

5.Recoil Starter

Place the unit on a flat, clear area. Firmly grasp throttle grip with left hand and rapidly pull recoil starter handle/rope (E) until engine fires (5 pulls maximum).

6.Choke

After engine fires (or 5 pulls), move choke lever to “Run” ( ) posi-

tion and pull starter handle/rope until engine starts and runs. Allow unit to warm up at idle for several minutes.

NOTE

If engine does not start with choke in “Run” position after 5 pulls, repeat instructions 2- 5.

7.After engine warm up, gradually depress throttle trigger to increase engine RPM to operating speed.

A

B

C

D

E

English

11