English

Shindaiwa Corporation

EPA PHASE 2 / CALIFORNIA TIER III EMISSION

CONTROL WARRANTY STATEMENT - WARRANTY RIGHTS AND OBLIGATIONS

The Environmental Protection Agency (EPA) and the California Air Resources Board (C.A.R.B.) and Shindaiwa Inc. are pleased to explain the emission control system warranty on your EPA Phase 2 / C.A.R.B. Tier III model year 2007 and later small off road engine (SORE). New small off road engines must be designed, built and equipped to meet stringent EPA and C.A.R.B. anti-smog standards. Shindaiwa Inc. warrants the emission control system on your small off road engine for the periods of time listed below provided there has been no abuse, neglect or improper maintenance of your small off road engine.

Your emission control system may include parts such as: carburetor/fuel injected system, ignition system, catalytic converter, fuel tank, fuel lines, fuel caps, valves, canisters, filters vapor hoses, clamps connectors, and other associated components. For certain hand-held products with engines less than or equal to 80cc displace- ment, the fuel tank is subject to the C.A.R.B. evaporative emission control warranty requirements of this section. Contact Shindaiwa Inc. for the models covered under the C.A.R.B. evaporative emission regulations.

Where a warrantable condition exists, Shindaiwa Inc. or its authorized service representative will repair your small off road engine at no cost to you including diagnosis, parts and labor.

MANUFACTURER'S WARRANTY COVERAGE:

The 2007 and later small off road engines are warranted for two years for certain emission related parts. If any emission-related part on your engine is defective, the part will be repaired or replaced by Shindaiwa Inc. or its authorized service representative.

OWNER'S WARRANTY RESPONSIBILITIES:

As the small off road engine owner, you are responsible for the performance of the required maintenance listed in your Operator's Manual. Shindaiwa Inc. recom- mends that you retain all receipts covering maintenance on your small off road engine, but Shindaiwa Inc. cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the small off road engine owner, you should however be aware that Shindaiwa Inc. may deny you warranty coverage if your small off road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifi- cations.

You are responsible for presenting your small off road engine to Shindaiwa Inc.’s authorized service center as soon as a problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you can contact Shindaiwa Inc. at 800-521-7733 or www.shindaiwa.com

EPA PHASE 2 / CALIFORNIA TIER III EMISSIONS DEFECT WARRANTY EXPLANATION

This is additional detailed information about the EPA PHASE 2/CALIFORNIA TIER III EMISSIONS DEFECT WARRANTY for your small off road engine.

WHAT DOES THIS WARRANTY COVER?

Shindaiwa Inc. warrants that your unit was designed, built and equipped to conform with applicable EPA and California emissions standards and that your unit is free from defects in material and workmanship that would cause it to fail to conform with applicable requirements within two (2) years. The warranty period begins on the date the product is delivered to a retail purchaser. This is your emission control

system DEFECTS WARRANTY.

HOW WILL A COVERED PART BE CORRECTED?

If there is a defect in a part covered by this warranty, Shindaiwa Inc.’s authorized service dealer will correct the defect.

You will not have to pay anything to have the part adjusted, repaired or replaced. This includes any labor and diagnosis for warranted repairs performed by the dealer. In addition, engine parts not expressly covered under this warranty but whose failure is a result of a failure of a covered part will be warranted.

Emissions System repairs covered under this warranty should be completed in a reasonable time, not to exceed 30 days.

IMPORTANT

If the diagnosis reveals no defect, the emission defect warranty does not apply.

WHAT PARTS ARE COVERED BY THE EPA PHASE 2/ CALIFORNIA TIER III 2007 & LATER SMALL OFF ROAD ENGINE EMISSIONS DEFECT WARRANTY?

Any emission related part not scheduled for, "required maintenance" (See Operator’s Manual, "SERVICE MAINTENANCE SCHEDULE") will be repaired or replaced within the warranty period. The repaired or replaced part will be war- ranted for the remaining Emissions Defect warranty period.

Any emission related part scheduled for replacement during "required mainte- nance" (See Operator’s Manual, "SERVICE MAINTENANCE SCHEDULE") is warranted for the period of time prior to the first scheduled replacement point for that part. Any such part repaired or replaced under warranty shall be warranted for the remainder of the period prior to the first scheduled replacement point for that part.

Any Shindaiwa Inc. approved replacement part may be used in the performance of any warranty maintenance or repairs on emission-related parts, and must be provided without charge if the part is still under warranty.

Any replacement part that is equivalent in performance and durability may be used in non-warranty maintenance or repairs, and shall not reduce the warranty obligations of Shindaiwa Inc.

The owner is responsible for the performance of the required maintenance described in the operator’s manual.

SPECIFIC EMISSION RELATED WARRANTED PARTS:

Choke

Carburetor (complete assembly or replaceable components)

Fuel Injection Assembly or replaceable components

Air Filter

Electronic Ignition System

Spark Plug

Catalytic Converter / Muffler Assembly

Fuel Tank (CARB only)

WHAT IS NOT COVERED BY THE EPA PHASE 2/ CALIFORNIA TIER III 2007 & LATER SMALL OFF ROAD ENGINE EMISSIONS DEFECT WARRANTY?

Any failure caused by abuse, neglect, improper maintenance.

Any failure caused by unapproved modifications, use of unapproved add-on parts/modified parts or unapproved accessories.

22

Page 22
Image 22
Shindaiwa EB212, 82051 Manufacturers Warranty Coverage, Owners Warranty Responsibilities, What does this Warranty COVER?

82051, EB212 specifications

The Shindaiwa 82051 and EB212 are top-tier products that cater to a variety of outdoor maintenance needs, particularly in the realm of landscaping and gardening. Shindaiwa, a well-known name in the outdoor power equipment market, consistently delivers high-quality equipment designed for reliability and performance.

The Shindaiwa 82051 is primarily recognized as a premium brushcutter, engineered to handle tough cutting jobs with ease. One of its standout features is its powerful 22.5 cc, 2-cycle engine, which ensures robust performance and efficient fuel consumption. This engine type provides exceptional torque and power, making it capable of tackling dense vegetation.

The 82051 model also boasts a lightweight and ergonomic design that enhances user comfort and control during operation. The handlebars are designed for a relaxed grip, and the overall weight of the unit ensures that fatigue is minimized, allowing users to work longer without discomfort. Additionally, the product comes equipped with a dynamic shoulder strap that distributes the weight evenly, thus providing improved balance and maneuverability.

Commercial users will appreciate the Shindaiwa 82051's durability, as it features high-quality materials that withstand the rigors of daily use. The air filtration system is designed to reduce engine wear, prolonging the life of the machine and ensuring reliability even under rigorous conditions.

On the other hand, the Shindaiwa EB212 leaf blower is an essential tool for those in need of effective yard cleanup. This leaf blower features a powerful 21.2 cc engine, delivering an impressive airflow of up to 422 CFM (cubic feet per minute) and a maximum air speed of 165 mph. These features make the EB212 incredibly effective in managing debris, whether it be leaves, grass clippings, or other yard waste.

One of the highlighted technologies in the EB212 is the innovative two-stroke engine that ensures lower emissions without sacrificing performance, in line with environmental standards. The unit also features an ergonomic design with a comfortable grip and lightweight build, making it easy to maneuver for extended periods.

In summary, both the Shindaiwa 82051 and EB212 bring together power, efficiency, and user-centered designs. Their features cater to professionals and homeowners alike, standing out for their performance, durability, and comfort, making them indispensable tools for outdoor maintenance. Whether tackling stubborn brush or managing leaves, these machines reaffirm Shindaiwa's commitment to quality and innovation in outdoor power equipment.