Shindaiwa EB212, 82051 manual Spark plug, Cooling system, Cleaning Grill, English

English

Spark plug

Level 2.

Tools required: 3/4 in. Spark Plug deep socket, Feeler gauge

IMPORTANT

Use only BPMR-8Y spark plug otherwise severe engine damage may occur.

1.Remove spark plug and check for fouling, worn and rounded center electrode.

2.Clean the plug or replace with a new one. DO NOT sand blast to clean. Remaining sand will damage engine.

3.	Adjust spark plug gap by bending outer electrode.	0.65 mm
		(0.026 in.)
4.	Tighten spark plug to 150-170 kg/cm (130-150 in. lb.).

Cooling system

Level 2.

Tools required: 25-50 mm (1-2 in.) Cleaning brush, 3 mm Hex

Wrench, Cross Head Screwdriver

Parts Required: None, if you are careful.

IMPORTANT

To maintain proper engine operating temperatures, cooling air must pass freely through the cylinder fin area. This flow of air carries combustion heat away from the engine.

Overheating and engine seizure can occur when:

•Air intakes are blocked, preventing cooling air from reaching the cylinder.

•Dust and grass build up on the outside of the cylinder. This build up insulates the engine and prevents the heat from leaving.

Removal of cooling passage blockages or cleaning of cooling fins is considered “Normal Maintenance”. Any failure attributed to lack of maintenance is not warranted.

Cleaning Grill

1. Brush accumulated debris from crankcase intake grill above the fuel tank.

16