Shindaiwa EB633RT, 82050 EPA Phase 2/ C.A.R.B. TIER, Equipment Check, Emission Control, English

English

Equipment Check

WARNING

Use only Shindaiwa approved attachments. Serious injury may result from the use of a non-approved attach- ment combination. Shindaiwa, INC. will not be responsible for the failure of cutting devices, attachments or accessories which have not been tested and approved by Shindaiwa. Read and comply with all safety instruc- tions listed in this manual and safety manual.

•Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.

•Inspect fuel lines, tank and area around carburetor for fuel leaks. DO NOT operate unit if leaks are found.

•Do not use blower if any part is missing or damaged.

•Have repairs done only by an authorized Shindaiwa Service dealer.

•Do not use any attachment, accessory or replacement part unless it is recommended in this Operator's Manual.

Emission Control

EPA Phase 2/ C.A.R.B. TIER III

The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the fuel tank the

Control System is EVAP (Evaporative Emissions). Evaporative emission may be applicable to California models only.

IMPORTANT ENGINE INFORMATION

ENGINE FAMILY: 7EHXS.0214EKG DISPLACEMENT: 21.2 cc

EMISSION COMPLIANCE PERIOD : 300 HRS.

THIS ENGINE MEETS U.S. EPA PH2 EXH AND 2007 AND

LATER CALIFORNIA EXH AND EVAP EMISSION REGULA-

TIONS FOR S.O.R.E.. REFER TO OWNER'S MANUAL FOR

MAINTENANCE SPECIFICATIONS AND ADJUSTMENTS.

An Emission Control Label is located on the unit. (This is an EXAMPLE ONLY, information on label varies by engine FAMILY).

PRODUCT EMISSION DURABILITY

The 300 hour emission durability compliance period is the time span selected by the manufacturer certifying the engine emissions output meets applicable emissions regulations, provided that approved maintenance procedures are followed as listed in the Maintenance Section of this manual.