Changing the set destination number

v¢í¢Room Monitor

sScroll to the Call to: line.

X or §Delete§

Delete existing number.

¤Enter and save number as described in "Activating the room monitor and entering the number to be called" (page 46).

Deactivating the room monitor remotely

Preconditions: The phone must support touch tone dialling and the room monitor should be set for an external destination number.

¤Accept the call from the room monitor and press keys 9;.

The room monitor function will deactivate after the call ends. There will be no further room monitor calls. The other room monitor settings (e.g. no ringer tone) on the handset will remain activated until you press the display key §OFF§ on the handset.

To reactivate the room function with the same phone number:

¤Turn on the activation again and save with §Save§ (page 46).

Walky-talky mode

Walky-talky mode allows two handsets to communicate with each other, both inside and outside the range of the base station to which the handsets are registered.

Handsets that are to communicate with each other using walky-talky mode must meet one of the following conditions:

uThe handsets are all registered to the same base station.

uThe handsets are set to Best Base or are not yet registered.

Using several handsets

In walky-talky mode, if you press the talk key cor the handsfree key d, the call will go to all handsets that are in walky- talky mode. The connection is made with the first handset to accept the walky-talky call.

Please note:

uThe maximum range outdoors is 300 m.

uHandsets that are in walky-talky mode are not available for phone calls.

uThe handset operating times are greatly curtailed.

Activating/deactivating walky-talky mode

v¢í¢Walky-Talky

Use §OK§ to activate walky-talky mode. You can now:

§OFF§

Press the display key. Walky-

 

talky mode is switched off.

or

>Press the display key to open the menu.

The following functions can be selected with q:

Audio Settings

You can set Ringer Settings (see page 51) and Advisory Tones (see page 52) for walky-talky mode.

Room Monitor

You can use the handset in walky-talky mode as a room monitor.

Using a handset in walky-talky mode as a room monitor

¨¢Room Monitor

¤ Change multiple line input:

Room M.:

Select On to activate.

Level:

Set noise level sensitivity (Low or High).

¤Save changes (page 65).

47