Appendix
Care
¤Wipe the base station, charging cradle and the handset with a damp cloth (do not use solvent) or an antistatic cloth.
Never use a dry cloth. This can cause a build up of static.
Contact with liquid !
If the handset has come into contact with liquid:
1.Switch off the handset and remove the battery pack immediately.2.Allow the liquid to drain from the hand- set.
3.Pat all parts dry, then place the handset with the battery compartment open and the keypad facing down in a dry, warm place for at least 72 hours (not in a microwave, oven etc.).
4.Do not switch on the handset again until it is completely dry.When it has fully dried out, you will normally be able to use it again.
Questions and answers
If you have any questions about using your phone, visit us at www.siemens.com/gigasetcustomercare at any time. The table below contains a list of common problems and possible solu- tions.
Registration or connection problems with a Bluetooth headset.
¥Reset the Bluetooth headset (see the user
¥guide for your headset).
Delete registration data from the handset when
¥page 56).
Repeat the registration process (see page 56).
The display is blank.
1. ¥The handset is not switched on.
Press and hold the end call key a.
2.¥The battery pack is flat. Charge/replace the battery pack (page 7).
The keys of a handset do not respond when pressed.
The¥ keypad lock is activated.
Press and hold the hash key #(page 10).
"Base station x" flashes on the display.
1. The handset is outside the range of the base station¥ .
Move the handset closer to the base sta- tion.
2. The base station's range is reduced because eco¥ mode is activated.
Deactivate eco mode (page 12) or reduce the distance between the handset and the base station.
3. The¥ handset has been
4. The¥ base station is not switched on.
Check the base station's mains adapter (page 7).
Base Search flashes in the display.
The handset is set to Best Base and no base sta-
¥is switched on or within range.
¥Move the handset closer to the base station. Check the base station's mains adapter (page 7).tion
Handset does not ring.
The¥ ringer tone is switched off. Activate the ringer tone (page 51).
You cannot hear a ringer/dialling tone from the fixed network.
The phone cord supplied has not been used or has been replaced by a new cord with the wrong¥ jack connections.
Please always use the phone cord supplied or ensure that the jack connections are correct when purchasing from a retailer (page 7).
Error tone sounds after system PIN prompt.
You¥ have entered the wrong system PIN. Reset the system PIN to 0000 (page 58).
61