Using several handsets

You will hear the error tone (descending tone sequence) if you assign an internal number twice.

¤Repeat the procedure with a free number.

Using a handset as a room monitor

If the room monitor is activated, a previously stored destination number is called as soon as a set noise level is reached. You can store an internal or external number in your handset as the destination number.

The room monitor call to an external number stops after around 90 seconds. The room monitor call to an internal number (handset) stops after approx.

3 minutes (depending on the base sta- tion). While the room monitor is activated, all keys are locked except the end call key. The handset's speaker is muted.

When the room monitor is activated, incoming calls to the handset are indicated without a ringer tone and are only shown on the screen. The display and keypad are not illuminated and advisory tones are also turned off.

If you accept an incoming call, the room monitor mode is suspended for the duration of the call, but the function remains activated.

If you deactivate then reactivate the hand- set, the room monitor mode remains acti- vated.

Caution!

–You should always check the operation of the room monitor before use. For example, test its sensitivity. Check the connection if you are diverting the room monitor to an outside number.

–When the function is switched on the hand- set's operating time is severely reduced.

If necessary, place the handset in the charging cradle. This ensures that the bat- teries do not run down.

–Ideally the handset should be positioned 1 to 2 metres away from the baby. The micro- phone must be directed towards the baby.

–The connection to which the room monitor is diverted must not be blocked by an acti- vated answer machine.

Activating the room monitor and entering the number to be called

v¢í¢Room Monitor

¤ Change multiple line input:

Room M.:

Select On to activate.

Call to:

External number:

Select the number from the directory (press display key Ò) or enter it directly. Only the last 4 digits are dis- played.

Internal number:

§Options§ ¢INT ¢§OK§ ¢s(select handset or Call All if all registered handsets are to be called) ¢§OK§.

Level:

Set noise level sensitivity (Low or High).

¤Press §Save§ to save the settings.

46