First steps

Please note:

To remove the battery pack, you must first press the bracket on the side.

Closing the battery cover

¤Align the battery cover parallel to the casing and press down until it clicks into place.

Attaching the belt clip

There are notches for attaching the belt clip on the side of the handset at the same height as the display.

¤Press the belt clip onto the back of the handset so that the protrusions on the belt clip engage with the notches.

Opening the battery cover

¤If fitted, remove the belt clip.

¤Lift the device with the keypad facing the palm of your hand.

¤Place the thumb of your other hand on the loudspeaker (a) and use the index finger of the same hand to press the groove at the top of the handset (b).

ab

¤Lift the cover.

Placing the handset in the charging cradle

¤Plug the charging cradle mains adapter into a mains power socket.

¤Place the handset in the charging cra- dle with the display facing forward.

The handset is already registered with the base station at the factory. INT 1 appears in the display. You do not have to re-register. If, nonetheless, you have to register your handset with the base station, see page 43.

Please note:

You can change the name of the handset (page 45).

To charge the battery pack, leave the handset in the charging cradle.

Please note:

–If the handset has switched itself off because the battery pack is flat and is then placed in the charging cradle, it will switch itself on automatically.

–Only place the handset in the charging cra- dle that is intended for it.

For questions and problems see page 61.

8