Siemens SL45 manual Data exchange, Sync Station, Integral modem, IrDA Infrared

Data exchange 69

Sync Station

You can establish a “fixed“ connection between the phone and the PC via the Sync Station.

p

￿&KDQJH￿ Activate infrared data transfer.

Indicator on the display:

LIf switched on.

MDuring transmission.

Integral modem

The phone has an integral modem that is used for data exchange via the infrared port or a cable.

o n

•Connect the mains power socket and the Sync Station n to the plug-in power supply.

Data transfer is not available unless the power supply unit is connected.

•Connect the Sync Station o to the serial interface of the PC using the connecting cable.

•Insert the phone into the Sync Station p and press downward until it engages.

)The contact message is displayed.

Switching your phone off and on after using the Data Exchange Software or Siemens QuickSync Software lets you use the inte- grated modem.

Technical data

Modem driver:

Conforms to the V.25 command set.

Speed:

Conforms to ITU-T standard V.22bis (2400, 4800 and 9600 bit/s).

Fax:

Fax at 2400, 4800, 7200 and 9600 bit/s.

Conforms to service class 2.

IrDA (Infrared)

￿0HQX￿ Î Setup Î IrDA

The infrared port integrated in the phone cannot be used unless the other device has a corresponding port.

Align the infrared windows with each other (max. distance 30 cm).

Setting on the PC

For fax or data transfer with communications software on your PC you must install a standard modem in its operating system control panel:

•Standard modem, 19,200 bit/s,

•Fax 9600 bit/s maximum,

•infrared 115,000 bit/s.