SX-600 User’s Manual
9
5. You should see the SX-600 in the list. If you do not see the SX-600 in the list, start again
and verify all the steps were made correctly for the installation up to this point again.
Right-Click the SX-600 (where the H/W address matches the one on the back label of
the SX-600) and click Configuration.
6. The IP Address settings of the SX-600 are for configuration purposes only. These will not
effect the network device you are connecting to. You do not normally need to change
these settings if you want to continue to make future configuration changes by connecting
directly from a PC with a crossover Ethernet cable.