Note:
After the tenth button press, the macro is automatically saved.
To save the macro at an earlier point, press the button MACRO
(11).
7. Press the desired button sequence. With each button
press, the counter goes up by one: MACRO1KEY? 03,
MACRO1 KEY? 04 etc. After the tenth button press, the
macro is saved and SUCCESSappears in the LCD display (2).
Note:
Note the programmed macros in the table "Personal macros"
at the end of these operating instructions.

Playing back a saved macro

Note:
The remote control must remain pointed at the device.
1. Press the MACRO button (11). MACRO KEY? appears in the
LCD display (2).
Note:
If no macro is saved under 1, for example, MACRO1 VOID
appears in the LCD display (2).
2. Press the number button (13) 1, 2or 3. The LCD display (2)
shows MACRO1, for example. The infrared symbol (22)
blinks and the saved button sequence is sent.
MACRO CLEAR
Clearing a saved macro.
1. Hold the Sbutton (5) pressed until CODE-SETUPappears
in the LCD display (2).
2. Press the down arrow button (6) repeatedly until MACRO
SETUPappears in the LCD display (2).
3. Press the right arrow button (6). MACRO SET appears in
the LCD display (2).
4. Press the down arrow button (6). MACRO CLEAR appears
in the LCD display (2).
5. Press the right arrow button (6). MACRO KEY? appears
in the LCD display (2).
6. Press the number button (13) 1, 2or 3. CONFIRM CLEAR
appears in the LCD display (2).
7. Press the r ight arrow button (6). First PLEASE WAIT...then
SUCCESSappears in the LCD display (2).
28
IB_KH2150_JOE23594_LB3bcI.qxd 05.08.2008 16:52 Uhr Seite 28