![](/images/new-backgrounds/1062102/6210263x1.webp)
STARTING TO SEW
The machine will be set to sew straight stitches when power switch is turned on.
CAUTION: To prevent accidents.
While sewing, special care is required around the needle.
As machine automatically feeds the fabric, do not pull nor push fabric.
A. START AND END OF SEAM
1.Check the presser foot (General Purpose Presser Foot). Refer to page 14 for changing the presser foot.
2.Place the fabric under the presser foot and lower the presser foot.
3.Hold back both threads and press the foot controller pedal.
Keep holding threads after sewing a few stitches.
Lightly guide the fabric while sewing.
4.Release the pedal when you reach end of seam.
5.Raise the presser foot lifter.
6.Remove the fabric and cut threads with the thread cutter, back to front.
B. REVERSE STITCHING
Reverse stitching is used for reinforcing the ends of the seams.
1.Place the fabric in position where back stitching is to be made and lower the presser foot.
2.Press reverse stitch button and press the foot controller pedal. Sew
3.Release the reverse button. Machine will change to forward sewing.
4.When you reach the end of seam, press reverse stitch button and sew
32
9910EFSt.pm6 | 32 | 2003.9.10, 8:46 PM |