![](/images/new-backgrounds/1040476/40476131x1.webp)
ATTACHING EMBROIDERY UNIT
1 | Connector cap |
Couvercle de connecteur |
CAUTION
Always be sure to turn off power to machine before installing embroidery unit.
Tapa de conector |
1. Turn off power to machine. Remove connector cap from machine.
*
3.Slide the embroidery unit onto machine fitting connectors on the machine and embroidery unit. Slide the embroidery unit as far as it will go until it clicks into place.
Hold handle of embroidery unit and pull it toward the left direction, and check that embroidery unit does not detach.
Note:
If embroidery unit is not securely installed, finished shape of pattern may deform. Make sure that embroidery unit is pushed in as far as it will go.
REMOVING EMBROIDERY UNIT
2
Connector
Connecteur
Conector
Handle
Poignée
Mango
Release lever
1Support de cerceau Palanca de liberación
CAUTION
Always be sure to turn off power to machine before installing embroidery unit.
∗Turn off power to machine.
∗Remove embroidery hoop from machine. (Refer to pages 70 - 71.)
1.Holding handle of embroidery unit, carefully slide toward the left while pressing release lever.
Note:
Do not pull carriage when removing embroidery unit.
Handle
2 Poignée
Mango
2.Insert the tab at the bottom of connector cap first, and push in the top of the connector cap with your finger as illustrated.
| Connector cap |
Connector cap | Couvercle de connecteur |
Couvercle de connecteur | Tapa de conector |
Tapa de conector |
|
Tab |
|
Languette |
|