Adjustments, Positive Stops Adjustment

SM 2610008289 02-10:3310 Table Saw 2/2/10 8:38 AM Page 30

Adjustments

90° and 45° Positive Stops

Adjustment

!	WARNING	To prevent personal injury, always dis connect the
		plug from power source before mak ngi any

adjustments.

The saw has positive stops that will quickly position the saw blade at 90° or 45° to the table. Make the following adjustments only if necessary.

NOTE: 90° and 45° blade adjustment screws require a 5 mm Allen wrench (not supplied) and a 10 mm wrench or socket (not supplied) for adjustment. To access the 10 mm jam nut attached to the 90° and 45° adjustment screws, turn the saw on its left side. Make sure the saw is secure.

Adjusting the 90° Stop:

1.Raise the blade to the maximum height by turning the control wheel 1 counterclockwise (Fig. 7).

2.Loosen the blade lock knob 2. Push in the blade elevation/tilting control wheel 1 and rotate clockwise as far as possible (Fig. 7).

3.Place a combination square on the table and against the blade to determine if the blade is at a 90° angle to the table (Fig. 8).

4.If the blade is not at a 90° angle to the table, loosen the jam nut (underneath table) and turn the 90° adjusting socket head screw 3 (Fig. 9) left to reduce the angle or right to increase the angle.

Adjusting the 45° Stop:

1.Raise the blade to the maximum height by turning the control wheel 1 counterclockwise (Fig. 7).

2.Loosen the blade lock knob 2. Push in the blade elevation/tilting control wheel 1 and rotate counterclockwise as far as possible (Fig. 7).

3.Place a combination square on the table and against the blade to determine if the blade is at a 45° angle to the table (Fig. 8).

4.If the blade is not at a 45° angle to the table, loosen the jam nut (underneath table) turn the 45° adjusting socket head screw 4 left to reduce the angle or right to increase the angle (Fig. 9).