Smeg smeg Double Oven Installing The Appliance, Electrical connection, Instructions for the user

EN

Instructions for the user

12.INSTALLING THE APPLIANCE

12.1 Electrical connection

The identification plate bearing the technical data, serial number and brand name is visibly positioned on the appliance.

Do not remove this plate for any reason.

The appliance must be connected to earth in compliance with electrical system safety regulations.

If the appliance is connected to the power supply network by means of a fixed connection, install a multipolar cut-out device on the power supply line, in accordance with the installation rules, located near the appliance and in an easily reachable position.

If a plug and socket connection is being used, make sure that the plug and socket are compatible. Avoid use of adapters and shunts as these could cause overheating and risk of burns.

Use H05VV-F type rubber cable and during positioning ensure that there is no contact with the metallic parts of the external frame of the appliance To access the terminal block, remove the rear cover of the appliance as described in paragraph "12.2 Cable replacement". If necessary, change the position of the jumpers on the terminal block as shown in the figure, then connect the cables, ensuring that the earth cable is at least 20 mm longer than the others. Secure the power cable to the appliance using the included cable ties.

WARNING: The values indicated above refer to the cross-section of the internal conductor.

220 - 240V ~

Three pole 3 x 4 mm² H05VV-F

20 mm

380 - 415V 2N~

Four pole 4 x 1.5 mm² H05VV-F

20 mm

34