Smeg smeg Double Oven, DOSCA36X-8 Positioning the oven, Instructions for the installer

Models: smeg Double Oven DOSCA36X-8

1 37
Download 37 pages 40.31 Kb
Page 35
Image 35
12.3 Positioning the oven

EN

Instructions for the installer

12.3 Positioning the oven

Never use the oven door to lever the oven into place when fitting. Avoid exerting too much pressure on the oven door when open.

It is recommended to install the oven with the help of a second person.

The base on which the oven is resting must be complete as shown in the illustrations below.

Under the large oven door, the counter must not protrude at least 1 cm. This is in order to allow complete opening of the door.

The oven is designed for mounting into any piece of furniture as long as it is heat-resistant. For positioning, follow the dimensions of the counter indicated in figure 1-2-3and the operational dimensions of the oven indicated in figure 4-5. Depending on the installation possibilities a ventilation opening must be prepared for the appliance. This opening must be

or on the lower/front part of the counter (figure 1) for a total surface of at least 200 cm².

either on the upper/rear part of the counter (figure 2) of 35-40 mm deep;

To secure the appliance to the counter, screw in 4 screws through the holes in the frame indicated in figure 6.

36

Page 35
Image 35
Smeg smeg Double Oven, DOSCA36X-8 installation instructions Positioning the oven, Instructions for the installer