Instructions for the installer
EN
12.2 Cable replacement
•Unscrew the securing screws from the cover terminal;
•Remove the tabs from the cover terminals;
•Loosen the cable securing screws from the lower part of the rear of the
oven ;
•Loosen the terminal cables;
•Replace the cable securing it to the terminal as described on the label on the rear of the appliance;
•When the cable has been replaced repeat the steps described above in reverse.
1
2
3
Make sure that the cables follow the best route in order to avoid any contact with the oven.
WARNING: The tightening torque of the screws of the terminal supply wires must be 1.5 - 2 Nm.
35