Instructions for the installer

2. INSTALLATION OF THE APPLIANCE

It is the law that all gas appliances are installed by authorised persons. Clearance around the cooker must comply with the requirements of AS5601.

2.1 Electrical connection

Make sure that the power lineltagevo matches the specifications indicated on the rating plate located inside the storage compartment.

This rating plate must never be removed.

On the power line, install a two-pole cut-off device with contact cut-off distance greater than or equal to 3 mm, located in an easily accessible position near the unit.

The wire section on the cable must not be less than 1.5 mm2 (3 x 1.5 cable), keeping in mind that the end to be connected to the cooker must have the ground wire (yellow- green) longer by at least 20 mm. Use only the special cables available at our Service Centres.

The manufacturer declines all responsibility for damage to persons or things caused by non-observance of the above prescriptions or by interference with any part of the appliance.

Overall dimensions: location of gands electrical connection points (all

measures in mm).

A60

B 410

C 100

D 150

6

Page 4
Image 4
Smeg FS61MFXLP, FS60WHNG Installation of the Appliance, Electrical connection, This rating plate must never be removed