![](/images/new-backgrounds/1111868/11186849x1.webp)
Maintenance
Driven Disc Replacement (Continued) | Driven Disc Bearing Replacement |
| ||||||
2. Using needle nose pliers, unhook the drive spring |
|
|
|
|
|
| ||
|
|
| ! | WARNING | ! | |||
| (A, Figure 29) and slide the driven disc assembly |
|
|
| ||||
| off the hex shaft. |
|
| DO NOT attempt any maintenance, adjustments or | ||||
3. Remove the two snap rings (A, Figure 30) which |
| service with engine and blade running. STOP engine | ||||||
| secure the rubber driven disc (B) to the driven disc |
| and blade. Disconnect spark plug wire and secure | |||||
| assembly. |
|
| away from spark plug. Engine and components are | ||||
4. Install a new rubber driven disc onto the driven |
| HOT. Avoid serious burns, allow sufficient time for all | ||||||
| disc assembly, and secure with the retaining rings. |
| components to cool. |
| ||||
5. Reverse the above procedures for reassembly and |
|
|
|
|
|
| ||
IMPORTANT: The bearing on these machines is |
| |||||||
| installation of the driven disc assembly. |
| ||||||
|
|
| staked into the thrust plate. The bearing will have to be | |||||
|
|
| driven out with a mallet and a large punch. A new bear- | |||||
|
|
| ing with four retaining screws will have to be purchased | |||||
|
|
| to replace existing bearing. |
| ||||
|
|
| If the driven disc bearing requires replacement, replace | |||||
|
|
| the bearing as follows: |
| ||||
|
|
|
| 1. Remove the driven disc assembly. Refer to the | ||||
|
| Reproduction |
| |||||
| A |
|
|
|
| Section entitled “Driven Disc Replacement”. |
| |
|
|
| 2. Remove both s ap ri gs (A, Figure 30) that |
| ||||
|
|
|
|
|
| secure the rubber driven disc (B) to the thrust |
| |
|
|
| 3. | plate. |
|
| ||
|
|
| Slide he rubber driven disc hub out of the bearing. | |||||
|
|
| 4. | Drive out | he ex sting bearing (C). |
| ||
|
|
|
| 5. Install a new bearing and secure to the thrust plate | ||||
|
|
|
|
|
| with fo | retaining screws. Tighten the screws |
|
|
|
|
|
|
| sec rely. |
|
|
|
|
|
| 6. Reassemble the components in reverse order. |
| |||
Figure 29: Removing the driven disc assembly | NOTE: Be sure to replace the shim washer (D) when | |||||||
|
|
| reassembling the driven disc assembly. |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| D |
|
C |
A
B |
Figure 30: Replacing the driven disc
en
25