Maintenance
Replacing the Bearing On the Pulley End | Belt Service |
|
|
| ||||||
Of the Hex Shaft |
|
|
|
|
|
|
|
| ||
|
| ! | WARNING |
| ! | |||||
| ! | WARNING | ! |
|
| |||||
|
| DO NOT attempt any maintenance, adjustments or | ||||||||
DO NOT attempt any maintenance, adjustments or |
| service with engine and blade running. STOP engine | ||||||||
service with engine and blade running. STOP engine |
| and blade. Disconnect spark plug wire and secure | ||||||||
and blade. Disconnect spark plug wire and secure |
| away from spark plug. Engine and components are | ||||||||
away from spark plug. Engine and components are |
| HOT. Avoid serious burns, allow sufficient time for all | ||||||||
HOT. Avoid serious burns, allow sufficient time for all |
| components to cool. |
|
|
| |||||
components to cool. |
|
|
|
|
|
|
|
| ||
| On | |||||||||
To replace the bearing on the pulley end of the hex | 32) transmits power from the engine pulley (B) to the | |||||||||
shaft, proceed as follows: |
| drive disc (C). The drive disc powers the | ||||||||
1. | Hold the hex shaft with an adjustable wrench held | which engages the transmission that powers the rear | ||||||||
2. | next to the pulley. |
| wheels. Should these belts become worn, they could | |||||||
Remove the 3/8” hex lock nut (B, Figure 31), | cause slippage, which would impair mower perfor- |
| ||||||||
3. | located on the outside of the right wheel bracket. | mance. The condition of the engine belt and |
| |||||||
Remove the holder (A), | belt should be checked after every 25 hours of mower | |||||||||
| (D). | B |
| operation. |
|
|
|
| ||
4. |
| Reproduction |
|
|
| |||||
Install the new bearing. |
| Engine Drive Belt Replacement (Stretch | ||||||||
5. | Carefully install the new | |||||||||
6. | the new bearing. |
| Type Belts) |
|
|
| ||||
Install the bearing holder, and secure with screws. |
| 1. Empty | he fuel ank. |
|
|
| ||||
7. | Install the 3/8” hex lock nut. |
|
| 2. Note he belt routing (Figure 32). There is no idler | ||||||
|
|
|
|
|
| pulley | hese models to disconnect. |
|
| |
|
|
|
|
|
|
|
| A |
|
|
|
| D | C |
|
|
|
|
| C |
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
A | B |
|
Figure 31: Replacing the hex shaft bearing | Figure 32: Engine drive belt routing |
26 | www.snapper.com |