26 Email Security Software
1
Slide the pins away from the rail-mount flange:
Press behind the slide-rail release latch 1 and hold it to prevent the rail from sliding back. Press the tab 2 away from the rail. Press the tab 3 back, and slide the rear rack-bracket pins away from the rail-mount flange4. Slide the pins back until the bracket stays in an open position.
Attention: Do not remove tab 5unless you are installing the rails on a non IBM rail-mount flange with a thickness greater than 3.175 mm (0.125 in.).
If you remove tab 5, you must insert an M6 screw through the bottom hole of the rail-mount flange 4 on all four flanges of the rack.
2
Pins extended through:
• Rack-mount flange
• Rail-mount flange
Pins not extended through:
•Rack-mount flange
•Rail-mount flange
Attach the rear rail-adjustment bracket to the rack:
Place the rack-mount flange 1 between the rail-mount flange and the rack-bracket pins. Press the tab 2; the rack-bracket pins snap into place, sliding through the rack-mount flange1 and rail-mount flange. Lift the slide-rail release latch 3, and then slide the front rail toward the front of the rack.
Attention: Make sure that the rail is securely clamped against the rack-mount flange.
