SonicWALL Internet Security Appliances manual SonicWALL TELE3 SP Back Panel, TELE3 SP Modem Port

SonicWALL TELE3 SP Back Panel

The SonicWALL TELE3 SP back panel is shown below, followed by a description of each item.

Cooling Vents

5VDC,2A
Power input	Reset Switch	10Mbps/100Mbps	10Mbps/100Mpbs	WAN Modem Port
	CLI Port	LAN Ethernet Port	WAN Ethernet Port

The SonicWALL TELE3 SP Back Panel Description

•Power Input

Connects to the external power supply that is provided with the SonicWALL TELE3 SP. The use of an Uninterruptible Power Supply (UPS) is recommended to protect the SonicWALL TELE3 SP against damage or loss of data due to electrical storms, power failures, or power surges.

•Reset Switch

Erases the firmware and resets SonicWALL TELE3 SP to its factory clean state.

•CLI (Command Line Interface) Port

DB-9 RS-232 Serial port allows out of band management of the SonicWALL TELE3 SP using a v.90/v.92 US Robotics external modem or a null-modem cable.

•(2) Twisted Pair (10Base-T, 100Base-T) Ethernet Ports

(2) Auto switching 10Mbps/100Mbps Ethernet ports provide connectivity for both Ethernet and Fast Ethernet networks. The Ethernet ports connect the SonicWALL TELE3 SP to the LAN and WAN using Twisted Pair cable with RJ45 connectors.

•TELE3 SP Modem Port

A V.90 internal modem provides dial-up access to establish connectivity to the Internet. It uses a standard RJ-11 telephone cord.

•Cooling Vents

The SonicWALL TELE3 SP is convection cooled; an internal fan is not necessary. Do not block the cooling vents.

•Test

•Lights up when the SonicWALL is powered up and performing diagnostic tests for proper oper- ation. These tests take up to 5 minutes.

Page 244 SonicWALL Internet Security Appliance Administrator’s Guide