Page 68 SonicWALL Internet Security Appliance Administrator’s Guide
Configuring Your TELE3 SP in Modem Only ModeConfiguring the Network Settings
Follow these steps to configure your TELE3 SP to use only the modem for Internet access:
1. When the Installation Wizard launches, follow the steps in your Quick Start Guide until the Set
Your Password page appears. Enter and confirm your new pas swor d.
Tip If you do not set a new password, the Installation Wizard relaunches when the SonicWALL is
rebooted.
2. Continue with the Installation Wizard. A warning message appears alerting you that no WAN
connection was detected.
3. Select Assigned you a single static IP address and click Next.
4. The Use Network Address Translation window is displayed. Click Next.
5. Leave the default val ues of 0.0.0.0 in t he SonicWALL WAN IP Ad dress field and the WAN
Gateway (Router) Address field. Leave the def ault setti ng of 255.255 .255. 0 in the S ubnet Mask
field. If your dial-up ISP has given you DNS Server IP address(es), enter the address(es) in the
DNS Server Address fields. If not, then leave the DNS Server Address fields blank.
6. Leave the default values in the SonicWALL LAN IP address field and Subnet M ask field.
7. If yo ur TELE3 S P acts as th e DHCP ser ver on you r network, select Enable DHCP Server and click
Next. If not, click Next.
8. Click Print this Page to print out the network settings of the TELE3 SP. Click Next.
9. Click Restart to enable the network settings on the TELE3 SP.
Configuring the Modem Settings
After your TELE3 SP has resta rted, log into it using the SonicWALL LAN IP ad dress. Click Modem, and
configure the dial-up connection settings by creating a Modem Profile TELE3 SP. Refer to the
Modem configur ation steps in the sect ion “Configuring Mode m Profiles” on page 61.
Tested Internet Service Providers
The following Internet Serv ice Providers (ISPs) have successfully t ested with the TELE3 SP:
ISP Additional Chat Script Required?
AT&T No
MSN No
Earthlink No
High Stream No
UUnet No