Applying Power to the SonicWALL SRA

1.Plug one end of the power cord into the SonicWALL SRA 1200/4200 and the other into an appropriate power outlet.

2.Turn on the power switch located on the rear of the appliance next to the power cord.

The 'Pwr' LED on the front panel lights up blue when the appliance is turned on. The 'Test' LED lights up yellow and may blink for up to a minute while the appliance performs a series of diagnostic tests. When the 'Test' LED is no longer lit, the SonicWALL SRA 1200/4200 is ready for configuration.

PWR TEST ALARM

If the 'Test' or 'Alarm' LEDs remain lit, or if the 'Test' LED blinks red after the SonicWALL SRA 1200/4200 has booted, restart the appliance. For more troubleshooting information, refer to the SonicWALL SSL VPN Administrator’s Guide.

Accessing the Management Interface

To access the Web-based management interface of the SonicWALL SRA 1200/4200:

1.Connect one end of an Ethernet cable into the ‘X0’ port of your SonicWALL SRA 1200/4200. Connect the other end of the cable into the computer you are using to manage the SonicWALL SRA 1200/4200.

2.Set the computer you use to manage the

SonicWALL SRA 1200/4200 to have a static IP address in the 192.168.200.x/24 subnet, such as 192.168.200.20. However, do not use 192.168.200.1, as this address will conflict with the appliance.

3.Open a Web browser, and enter http://192.168.200.1 (the default X0 management IP address) in the Location or Address field.

Note: A security warning may appear. Click Continue to this website or OK to accept the certificate and continue.

SonicWALL SRA 1200/4200 Getting Started Guide Page 9

Page 10
Image 10
SonicWALL SRA 1200/4200 manual Applying Power to the SonicWALL SRA, Accessing the Management Interface