22 | Product Guide |
3.Use an awl or other sharp object to punch 4 small holes through 4 of the marked locations on the template. (If additional reinforcement is desired, 2 spare screws and anchors are included in the wall mount kit.) Placement may vary but holes should be located toward the corners, away from center.
4.Remove the template from the wall.
5.Drill pilot holes.
Because the anchors and screws are designed to be
Wall Material | Pre Drill | Use Wall Anchors | Use Screws |
|
|
|
|
Wood Stud | with 1/8” (3mm) bit | No | Yes |
|
|
|
|
Drywall (no stud) | with 3/16” (4.5mm) bit | Yes | Yes |
Hard wallboard or double board | with 3/16” (4.5mm) bit | Yes | Yes |
Plaster | with 1/4” (6.5mm) bit | Yes | Yes |
Concrete or Brick | with 1/8” (3mm) bit | Yes | Yes |
6.Insert and secure the wall anchors (supplied in the wall mount kit).
•If you are drilling into wood stud, do not use the wall anchors.
•If you are drilling into Sheetrock, screw the wall anchors into the drywall with a Phillips head screwdriver until the head is flat against or slightly below the wall surface, being careful not to overtighten.
