Using the sub units

When a radio station is tuned on the main unit, you can listen to that station by following the steps below.

To tune in a radio station using the sub units, that station needs to be preset beforehand (see “To call up a preset radio station using the sub units” (page 29)).

1 Select the tuner channel.

Press S-AIR CH repeatedly until “TUNER” appears in the display.

2 Select “FM” or “AM.”

Press and hold S-AIR CH until “FM” changes to “AM” or vice versa.

To tune in a station with a weak signal using the main unit

If “TUNED” does not appear and the scanning does not stop, press TUNING +/on the remote (or TUNING/ SELECT +/on the unit) repeatedly to tune in the desired station.

To reduce static noise on a weak FM stereo station using the main unit

1Press SYSTEM MENU on the unit.

2Press TUNING/SELECT +/on the unit repeatedly until “FM MODE” appears, then press ENTER on the unit.

3Press TUNING/SELECT +/on the unit repeatedly until “MONO” appears, then press ENTER on the unit.

There will be no stereo effect, but the reception will improve.
Presetting radio stations

You can preset your favorite radio stations and tune them in instantly by selecting the corresponding preset number.

Use the main unit to preset the radio stations.1 Tune in the desired station.See “Listening to the radio using the S-AIR connection” (page 27).2 Press SYSTEM MENU on the unit.

3 Press TUNING/SELECT +/ on the unit repeatedly until “MEMORY” appears, then press ENTER on the unit.

Preset number

4 Press TUNING/SELECT +/on the unit repeatedly to select your desired preset number.

If another station is already assigned to the selected preset number,

the station is replaced by the new stations.
28GB