The main unit is paired with another S-AIR sub unit. Cancel pairing.

Place so that the main unit and the sub units are separated from other wireless devices.

Stop using any other wireless devices.

The main unit or the sub unit is turned off. Make sure the power supply cord and the power cord are connected and turn on the main unit and the sub units.

The S-AIR channel fails to change.Check that the main unit and the sub units are connected properly.

If you are using an optional S-AIR sub unit (such as the AIR-SA10) which is not compatible with the MULTI SOURCE mode, set the main unit to the PARTY mode.

There is no sound.

If you use another S-AIR main unit, place it more than 8 m away from the main unit.

Confirm the S-AIR IDs of the main unit and the sub units.

Check the pairing setting.Place so that the main unit and the sub units are closer.

Stop using any equipment that generates electromagnetic energy such as a microwave oven.

Place so that the main unit and the sub units are separated from other wireless devices.

Stop using any other wireless devices.

Change the S-AIR ID settings of the main unit and the sub units.

Turn off the main unit and the sub units and then turn them on again.

Check that the power supply cord and the power cord are connected securely and the main unit and the sub units are turned on.

Increase the volume of the sub units.

Check that headphones are not connected to the (headphones) jack on the rear panel of the sub units.

Change the RF CHANGE setting on the main unit (page 22).There is noise or the sound skips.

If you use another S-AIR main unit, place it more than 8 m away from the main unit.

Place so that the main unit and the sub units are closer.

Stop using any equipment that generates electromagnetic energy such as a microwave oven.

Place so that the main unit and the sub units are separated from other wireless devices.

Stop using any other wireless devices.

Change the S-AIR ID settings of the main unit and the sub units.

Do not place a mobile phone near the main unit and the sub units, as this may result in noise.

Change the RF CHANGE setting on the main unit (page 22).

Others
Continued 35GB