Sony CCD-TRV338 manual Dubbing/Editing

Dubbing/Editing

Symptom Cause and/or Corrective Actions

Cannot dub correctly using the A/V cSet [DISPLAY] to [LCD] in the (OTHERS) menu. (p. 58) connecting cable.

For	TRV280:	• The input signal is not NTSC. (p. 66)
Pictures from connected devices are
not displayed correctly.
For	TRV280:	cSet the input selector on the VCR correctly, then check the connection
Digital program editing does not		between your camcorder and the VCR. (p. 60)
function.		cWhen your camcorder is connected to a DV device that is not a Sony
		product via an i.LINK cable, select [IR] in step 9 of “Step 1: Preparing
		your camcorder and VCR for operation.” (p. 67)

cAdjust the synchronization of the VCR. (p. 68) cEnter a correct [IR SETUP] code. (p. 63)

cSelect the mode used to cancel recording pause again. (p. 68)

cSet your camcorder and the VCR more than 30 cm (12 in.) apart. (p. 68)

• The program may not be set to a blank section on the tape.

• You cannot perform the Digital program editing on a VCR that does not support [IR SETUP] codes, a DVD recorder and a DVD recorder equipped with an HDD, etc.

For	TRV280:		cWhile connecting via an i.LINK cable, select [IR] in step 9 of “Step 1:
The VCR is not responding properly			Preparing your camcorder and VCR for operation.” (p. 67)
during Digital program editing when			• You cannot perform the Digital program editing on a DVD recorder, a
it is connected via an i.LINK cable.			DVD recorder equipped with an HDD, etc.
For		TRV138/338:	• Your VCR and/or video camera recorder is not set correctly.
Easy Dubbing does not function.			cMake sure the input selector of the VCR is set to LINE. Also, make
			sure the power switch of the video camera recorder is set to VCR.

(p. 62)

• The [IR SETUP] code or [PAUSE MODE] is not set correctly.

c Select the correct [IR SETUP] code and [PAUSE MODE], according to your VCR. Then confirm VCR operation with the [IR TEST] function. (p. 62)

86

Troubleshooting