The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connections and operating procedures.
General
Problem | Cause/Solution |
|
|
No sound. | •Cancel the ATT function. |
| •Set the fader control to the center position for |
| systems. |
| •Rotate the dial in a clockwise direction to adjust the volume. |
The contents of the memory have been erased.
•The power cord or battery has been disconnected.
•The reset button was pressed.
nStore again into the memory.
Indications do not appear in the display.
Remove the front panel and clean the connectors. See “Cleaning the connectors” (page 30) for details.
CD/MD playback
Problem | Cause/Solution |
|
|
A disc cannot be loaded. | •Another CD is already loaded. |
| •The CD is forcibly inserted upside down or in the wrong way |
| (MD). |
|
|
Playback does not begin. | Defective MD or dusty CD. |
|
|
A disc is automatically ejected. | The ambient temperature exceeds 50°C (122°F). |
|
|
The operation buttons do not | Press the reset button. |
function. |
|
|
|
The sound skips due to | • The unit is installed at an angle of more than 60°. |
vibration. | • The unit is not installed in a sturdy part of the car. |
|
|
Radio reception
Problem | Cause/Solution |
Preset tuning is not possible. | • Memorize the correct frequency. |
| • The broadcast signal is too weak. |
|
|
Automatic tuning is not | The broadcast signal is too weak. |
possible. | nUse manual tuning. |
|
|
The “ST” indication flashes. | •Tune in the frequency accurately. |
| •The broadcast signal is too weak. |
| nSet to the MONO mode (page 13). |
|
|
32