TV programme reception does not fill the screen.

,Set the channel manually in “Channel Setting” in “Settings” setup (page 90).

,Select the correct source using the INPUT SELECT button, or select a channel of any TV programme using the PROG +/– buttons.

TV programme pictures are distorted.

,Reorient the TV aerial.

,Adjust the picture (see the TV’s instruction manual).

,Place the recorder and TV farther apart.

,Place the TV and any bunched aerial cables farther apart.

,The RF cable is connected to the AERIAL OUT jack on the recorder. Connect the cable to the AERIAL IN jack.

TV channels cannot be changed.

,The channel is disabled (page 93).

,A timer recording started, causing the channel to change.

The picture from equipment connected to the recorder’s input jack does not appear on the screen.

,If the equipment is connected to the LINE 1 – TV jack, select “L1” in the front panel display by pressing PROG +/– or INPUT SELECT.

If the equipment is connected to the LINE 2 IN jacks, select “L2” in the front panel display by pressing PROG +/– or INPUT SELECT.

If the equipment is connected to the LINE 4 IN jacks, select “L4” in the front panel display by pressing PROG +/– or INPUT SELECT.

If the equipment is connected to the LINE 3/ DECODER jack, select “L3” in the front panel display by pressing PROG +/– or INPUT SELECT.

,When an S video cable is connected to the recorder’s LINE 4 IN jack, set “Line4 Input” in “Video” setup to “S Video” (page 97).

The playback picture or TV programme from the equipment connected through the recorder is distorted.

,If the playback picture output from a DVD player, VCR, or tuner goes through your recorder before reaching your TV, the copy-protection signal applied to some programmes could affect picture quality. Disconnect the playback equipment in question and connect it directly to your TV.

The picture does not fill the screen.

,Set “TV Type” in “Video” setup in accordance with the screen size of your TV (page 95).

The picture does not fill the screen, even though the picture size is set in “TV Type” in “Video” setup.

,The picture size of the title is fixed.

The picture is black and white.

,Check that “Line1 Output” of “Scart Setting” in “Video” setup is set to the appropriate item that conforms to your system (page 96).

,If you are using a SCART cord, be sure to use one that is fully wired (21 pins).

106