Centre speaker

4.6 mm

10 mm

Foot pad

Surround speaker

4.6 mm

10 mm

Foot pad

Notes

•If you do not set the speaker correctly, the speaker may fall down and cause injury.

•Use screws that are suitable for the wall material and strength. In the case of a plaster board wall, attach the screws securely to a beam and fasten them to the wall.

•Install the speakers on a vertical and flat wall where reinforcement is applied.

•Contact a screw shop or installer regarding the wall material or screws to be used.

•Sony is not responsible for accident or damage caused by improper installation, insufficient wall strength, improper screw installation, or natural calamity, etc.

Installing the speakers on a wall (DAR-RH1000)

1Prepare screws (not supplied) that are suitable for the hole on the back of each speaker.

4 mm

Minimum 25 mm

Speaker rear hole

4.6 mm

10 mm

2Fasten the screws to the wall.

The screws should protrude 8 to 9 mm.

8 to 9 mm

3Attach the supplied wall-mount pads on the rear of the speaker.

Wall-mount pads

(7 × 7 mm, 3 mm thick)

20