After charging the battery
The CHG (charge) lamp turns off when the battery is fully charged. Disconnect the AC Adaptor from the DC IN jack.
To remove the battery pack
BATT (battery)
release button POWER switch
battery pack
1Set the POWER switch to OFF (CHG).
2Slide the battery pack out in the direction of the arrow while pressing the BATT (battery) release button down.
bNote
•If you do not use the battery pack for a long time, use up the battery pack completely before storing it. See page 129 about storage of the battery pack.
To check the remaining battery – Battery Info
DSPL/BATT INFO
POWER switch
You can check the battery’s current charge level and its current remaining recording time both during charging or when the power is turned off.
1Set the POWER switch to OFF (CHG).
2Open the LCD panel.
3Press DSPL/BATT INFO.
The battery information appears for about 7 seconds.
Keep the button pressed to view it for about 20 seconds.
BATTERY INFO
BATTERY CHARGE LEVEL
0% | 50% | 100% |
REC TIME AVAILABLE
LCD SCREEN: 76 min
VIEWFINDER: 85 min
ABattery charge level: Displays approximate remaining amount of power left in the battery pack.
BApproximate possible recording time using the LCD panel.
CApproximate possible recording time using the viewfinder.
Charging time
Approximate number of minutes required when you fully charge a fully discharged battery pack at 25°C (77°F). (10 – 30°C (50 – 86°F) recommended.)
Battery pack
125 |
,continued
started Getting
Getting started 17