Troubleshooting
In the recording and playback modes
Symptom | Cause and/or Corrective Actions |
The power does not turn on. | • The battery pack is not installed, or is dead or nearly dead. |
| c Install a charged battery pack (p. 10, 12). |
| • The AC adaptor is not connected to a wall outlet. |
| c Connect the AC adaptor to a wall outlet (p. 14). |
The end search function does not | • The tape was ejected after recording when using a tape |
work. | without cassette memory (p. 26, 30). |
| • You have not recorded on the new cassette yet (p. 26, 30). |
The end search function does not | • The tape has a blank portion in the beginning or middle |
work correctly. | (p. 125). |
The picture does not appear in the | • The LCD panel is open. |
viewfinder. | c Close the LCD panel (p. 20). |
| • When the viewfinder is not pulled out until it clicks, the |
| picture does not appear in the viewfinder. |
| c Pull out the viewfinder until it clicks (p. 18). |
The battery pack is quickly | • The temperature of the environment is too low. |
discharged. | • The battery pack is not fully charged. |
| c Charge the battery pack fully again (p. 10). |
| • The battery pack is completely dead, and cannot be |
| recharged. |
| c Replace with a new battery pack (p. 12). |
Additional
The battery remaining indicator does not indicate the correct time.
•You have used the battery pack in an extremely hot or cold environment for a long time.
•The battery pack is completely dead, and cannot be recharged.
c Replace with a new battery pack (p. 10).
•The battery is dead.
cUse a charged battery pack (p. 10, 12).
Information
The power goes off although the | c Charge the battery pack fully again so that the indication |
battery remaining indicator indicates | on the battery remeining indicator is correct (p. 10). |
that the battery pack has enough |
|
power to operate. |
|
|
|
The cassette cannot be removed from | • The power source is disconnected. |
the holder. | c Connect it firmly (p. 12, 14). |
| • The battery is dead. |
| c Use a charged battery pack (p. 10, 12). |
The % and Z indicators flash and no • Moisture condensation has occurred. | |
functions except for cassette ejection | c Remove the cassette and leave your camcorder for at |
work. | least 1 hour to acclimatize (p. 139). |
indicator does not appear when | • The |
using a tape with cassette memory. | c Clean the |
Remaining tape indicator is not | • The q REMAIN is set to AUTO in the menu settings. |
displayed. | c Set it to ON to always display the remaining tape |
| indicator (p. 89). |
(continued on the folowing page)
131